Each PRT12EM series reader can be used as an universal identification point connected to the access controller or configured for autonomous work, as a simple access controller for a single door. In the first case, the reader’s functionality is limited only to reading an identifier (card/PIN) and sending data to an external controller, which takes further action. In case of work in a standalone mode, PRT12EM terminals can independently supervise a single door using data entered in the process of their configuration.

Features:
- EM 125 kHz (UNIQUE) cards
- Programmable data output formats: Wiegand 26-66bit, Magstripe (Clock and data), RACS (Roger), RS232
- Various ways of PIN and keypad codes transmission
- LED and Buzzer controlled through separate inputs
- Outdoor installation
- Can be used for EMC-4 card programming (free of charge RARC software is required)
- Programmed manually or from PC
- Free managing software (RARC)
- May operate as an offline standalone access controller
- 120 indexed users
- Authentication: Card and/or PIN
- Event log for 3000 transactions
- Built-in programmable 1.5A/30V relay output
- Two NO/NC inputs
- Two transistor outputs
- Operation with XM-2 I/O extension module
- Possible connection of additonal external PRT series reader (two way door control)
- Tamper
- CE mark

Technical Specification
Supply voltage: 10-15 VDC
Current consumption (average): 65mA (45mA for version without keypad)
Anti-sabotage protection (Tamper): NC contact, 50mA/24V, IP67
Reading distance: Up to 15 cm
Environmental class: Class IV, outdoor-general, temperature: -25ºC- +60ºC, relative humidity: 10 to 95% (non condensing)
Dimensions H x W x D: With standard enclosure base: 152.5 X 46 X 23 mm; With extended enclosure base: 152.5 X 46 X 35 mm
Weight: 150g
Approvals: CE