INELS Combined detector
Possibilities to use the DMD3-1:
- Motion detector
- Sensor luminescence
- Temperature measuring
- Humidity measurement
The unit is equipped with two communication interfaces:
- Installation iNELS BUS
- DALI
The motion detector is used to detect people moving in the area. Using the passive scanning infrared spectrum for detection.
Integrated luminescence sensor can be used for sensing current luminescence at the point of installation of the unit. This information can be used in tasks to maintain a constant luminescence. In space where it is possible, thanks to the contribution of natural light from the outside to adjust the artifi cial light, which can reduce energy consumption.
Setting the communication interface is done using the SET button.
The unit can be confi gured via the iNELS3 Designer & Manager software, which, among other things it is possible to:
- Set the desired function depending on detected motion.
- Resolve jobs based on the value of luminescence.
- Enable / disable the alarm LED on the detector housing.
DMD3-1 detector is designed for indoor installation and is not intended for outdoor use.
DMD3-1 detector is powered directly via the iNELS BUS installation (nominal 27 V DC) or DALI BUS (nominal 16 V DC).
Technical parameters
PIR scan type: single / dual
Default setup PIR: 99 dual
Temperature measuring: YES, built-in temperature sensor
Interface: Installation BUS iNELS DALI
Operating temperature: -20 .. +55 °C
Protection degree: IP20
Operation position: vertical
Dimension: Ø 76 x 73 mm
Weight: 81 g
Possibilities to use the DMD3-1:
- Motion detector
- Sensor luminescence
- Temperature measuring
- Humidity measurement
The unit is equipped with two communication interfaces:
- Installation iNELS BUS
- DALI
The motion detector is used to detect people moving in the area. Using the passive scanning infrared spectrum for detection.
Integrated luminescence sensor can be used for sensing current luminescence at the point of installation of the unit. This information can be used in tasks to maintain a constant luminescence. In space where it is possible, thanks to the contribution of natural light from the outside to adjust the artifi cial light, which can reduce energy consumption.
Setting the communication interface is done using the SET button.
The unit can be confi gured via the iNELS3 Designer & Manager software, which, among other things it is possible to:
- Set the desired function depending on detected motion.
- Resolve jobs based on the value of luminescence.
- Enable / disable the alarm LED on the detector housing.
DMD3-1 detector is designed for indoor installation and is not intended for outdoor use.
DMD3-1 detector is powered directly via the iNELS BUS installation (nominal 27 V DC) or DALI BUS (nominal 16 V DC).
Technical parameters
PIR scan type: single / dual
Default setup PIR: 99 dual
Temperature measuring: YES, built-in temperature sensor
Interface: Installation BUS iNELS DALI
Operating temperature: -20 .. +55 °C
Protection degree: IP20
Operation position: vertical
Dimension: Ø 76 x 73 mm
Weight: 81 g
