KNX / IP Interface for programming and monitoring
* IPI200 device can be connected to any KNX bus line for monitoring and programming purposes from PC via Ethernet connection.
* The device supports five simultaneous KNX / IP tunneling connections
* IPI200 as a width of only one module (18 mm) and is powered by the KNX bu
* The device is an interface between IP and KNX and can be used as programming interface for ETS software (ETS3 or higher)
* You can access the KNX bus from every point of your LAN
* The IP address can be obtained by a DHCP server or by manual configuration (ETS) respectively.
* The buttons and LEDs on the device allow a local diagnosis including the operating status and communication errors.
* IPI200 device can be connected to any KNX bus line for monitoring and programming purposes from PC via Ethernet connection.
* The device supports five simultaneous KNX / IP tunneling connections
* IPI200 as a width of only one module (18 mm) and is powered by the KNX bu
* The device is an interface between IP and KNX and can be used as programming interface for ETS software (ETS3 or higher)
* You can access the KNX bus from every point of your LAN
* The IP address can be obtained by a DHCP server or by manual configuration (ETS) respectively.
* The buttons and LEDs on the device allow a local diagnosis including the operating status and communication errors.